energy saving steam boiler Agent electric
HOT
Capacity:1-20t/h
Rated thermal efficiency: 100-104%
Fixed working pressure: ≤1.6MPa
Applicable fuel:natural gas etc.
HOT
Capacity:0.7-14MW
Rated thermal efficiency:96-98%
Fixed working pressure:≤1.25MPa
Applicable fuel:Natural gas, light oil, etc.
HOT
Capacity:0.7-2.8Mw
Rated thermal efficiency: 97.2-106%
Fixed working pressure:0.1MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:2.8-7.0Mw
Rated thermal efficiency:≥105.5%
Fixed working pressure:-0.02MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:99Kw
Rated thermal efficiency:97.2-104.4%
Fixed working pressure:1.0MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:0.5-4.0 t/h
Rated thermal efficiency:98%
Fixed working pressure:≤1.25MPa
Applicable fuel:electric energy
Due to the rising cost of chemical treatment, it is proposed that a pressurised deaerator be installed, operating at 0.2 bar g to raise the feedwater temperature to 105°C, reducing the solubility of oxygen to quantities typically measured in parts per billion. Steam, produced in the boiler at 10 bar g, is to be used as the heating agent.Get Price
Efm coal boiler parts. The new names for the venerable efm boiler and furnace are a result of testing that will allow current and future owners to burn biomass fuels in their units in addition to Our engineers developed an automatic stoker unit equipped with a coal hopper that held enough fuel for several days. 27, 2008 2:01 pm wow a 1956 stoker below a 1984 boiler. .Get Price
Oct 01, 2011 · Heat Recovery Steam Generators, Boiler Air Pollution Control, Boiler Services, Feedwater Heaters, Moisture Separator Reheaters, Surface Condensers Power-Generation and Energy-Saving Schemes. Enerbit. Software and Engineering Services for the Power Industry. Protection from Rust and Corrosion for Electric Power Equipment.Get Price
Boiler Efficiency Directive 92/42/EEC (BED) Boiler Efficiency Directive (92/42/EEC) is a European Directive that lays down harmonized conditions for the boilers efficiency. The scope of this scheme includes regulation 813/2013.Get Price
5.11 (1) Every high pressure boiler and every low pressure steam boiler in use at a work place shall be inspected (a) externally, at least once each year; and (b) internally, at least once every two years. (2) Every low pressure hot water boiler and every unfired boiler in use at a …Get Price
The quantity of steam which the boiler generates, usually measured in kg/h. For selecting a blowdown system, the most important figure is usually the maximum quantity of steam that the boiler can generate at full-load. When the above information is available the required blowdown rate can be determined using Equation 3.12.5Get Price
In other words, the steam boiler is overheating and excessive steam is coming out of the safety valve. The steam boiler PID sensor on top of the steam boiler will need to be disconnected from the brain unit in back, then the sensor removed without …Get Price
Apr 28, 2016 · If you have a contract for the installation of a boiler or heat distribution system on your customer's premises, the supplies of equipment and …Get Price
May 15, 2020 · Another option is to use electric boilers coupled with renewable power sources, though as noted in Section 4.2, boilers that burn thermal fuel are highly efficient, so energy costs of electric boilers are likely to be higher (absent policy such as a carbon price, and excepting systems where steam itself is used inefficiently).Get Price
The steam from the boilers is used to turn the blades of a giant fan or propeller, called a turbine. The turbine turns a coil made of copper wire (the rotor) inside a magnet (the stator). Together they make up the generator. The generator produces an electric current, which is sent to the homes and factories of consumers via power lines.Get Price
Feel free to reach out if you want to collaborate with us, or simply have a chat.